Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 212)

Getting Started Manual
LM10Zi-GSM-E Rev A 205
Specifications
NOTE: Specifications are subject to change without notice.
Detailed specifications are maintained on the product Datasheet
available at www.teledynelecroy.com. Always check the website for the
most up to date specifications.
Certifications
This section contains the instrument’s Electromagnetic Compatibility
(EMC), Safety and Environmental certifications.
EMC Compliance
EC D
ECLARATION OF
C
ONFORMITY
- EMC
The oscilloscope meets intent of EC Directive 2004/108/EC for
Electromagnetic Compatibility. Compliance was demonstrated to the
following specifications as listed in the Official Journal of the European
Communities:
EN 61326-1:2006, EN 61326-2-1:2006 EMC requirements for electrical
equipment for measurement, control, and laboratory use.
1
Electromagnetic Emissions:
CISPR 11:2003, Radiated and conducted Emissions, Group 1, Class A
2 3
EN 61000-3-2:2006 Harmonic Current Emissions, Class A
EN 61000-3-3/A2:2005 Voltage Fluctuations and Flickers, Pst = 1
Electromagnetic Immunity :
EN 61000-4-2:2001 Electrostatic Discharge, 4 kV contact, 8 kV air, 4 kV
vertical/horizontal coupling planes
4
EN 61000-4-3:2006 RF Radiated Electromagnetic Field, 3 V/m, 80-1000
MHz; 3 V/m, 1400 MHz - 2 GHz; 1 V/m, 2 GHz - 2.7 GHz
4
EN 61000-4-4:2004 Electrical Fast Transient/Burst, 1 kV on power supply
lines, 0.5 kV on I/O signal data and control lines
4