Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 96)

P A R T T W O : C O M M A N D S
90
ISSUED: February 2005 WM-RCM-E Rev D
S HORT
F ORM
L ONG F ORM W HAT THE C OMMAND OR Q UERY D OES
*ESR? *ESR? Reads and clears the Event Status Register (ESR).
EXR? EXR? Reads and clears the EXecution error Register (EXR).
INE INE Sets the INternal state change Enable register (INE).
INR? INR? Reads and clears the INternal state change Register (INR).
IST? IST? Individual STatus reads the current state of IEEE 488.
*OPC *OPC Sets to true the OPC bit (0) in the Event Status Register (ESR).
*PRE *PRE Sets the PaRallel poll Enable register (PRE).
*SRE *SRE Sets the Service Request Enable register (SRE).
*STB? *STB? Reads the contents of IEEE 488.
*WAI *WAI WAIt to continue (required by IEEE 488)
WAVEFORM TRANSFER — T O P RESERVE AND R ESTORE W AVEFORMS
INSP? INSPECT? Allows acquired waveform parts to be read.
STO STORE Stores a trace in one of the internal memories M1–4 or mass storage.
STST STORE_SETUP Sets up waveform storage
TMPL? TEMPLATE? Produces a copy of the template describing a complete waveform.
TRFL TRANSFER_FILE Transfers ASCII files to and from storage media, or between scope and
computer.
WF WAVEFORM Transfers a waveform from the controller to the oscilloscope.
WFSU WAVEFORM_SETUP Specifies amount of waveform data for transmission to controller.