Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 151)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
145
ADDITIONAL INFORMATION
E XECUTION E RROR S TATUS R EGISTER S TRUCTURE (EXR)
Value Description
21 Permission error. The command cannot be executed in local mode.
22 Environment error. The oscilloscope is not configured to correctly process a command. For
instance, the oscilloscope cannot be set to RIS at a slow timebase.
23 Option error. The command applies to an option which has not been installed.
24 Unresolved parsing error.
25 Parameter error. Too many parameters specified.
26 Non-implemented command.
27 Parameter missing. A parameter was expected by the command.
30 Hex data error. A non-hexadecimal character has been detected in a hex data block.
31 Waveform error. The amount of data received does not correspond to descriptor indicators.
32 Waveform descriptor error. An invalid waveform descriptor has been detected.
33 Waveform text error. A corrupted waveform user text has been detected.
34 Waveform time error. Invalid RIS or TRIG time data has been detected.
35 Waveform data error. Invalid waveform data have been detected.
36 Panel setup error. An invalid panel setup data block has been detected.
50 No mass storage present when user attempted to access it. *
51 Mass storage not formatted when user attempted to access it. *
53 Mass storage was write protected when user attempted to create a file, to delete a file, or to format
the device.
*
54 Bad mass storage detected during formatting. *
55 Mass storage root directory full. Cannot add directory. *
56 Mass storage full when user attempted to write to it. *
57 Mass storage file sequence numbers exhausted (999 reached). *
58 Mass storage file not found. *
59 Requested directory not found. *
61 Mass storage filename not DOS compatible, or illegal filename. *
62 Cannot write on mass storage because filename already exists. *
* Only with memory card or removable hard disk option.