Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 95)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
89
S HORT
F ORM
L ONG F ORM W HAT THE C OMMAND OR Q UERY D OES
MTPC? MT_PF_COUNTERS? Returns pass/fail result.
MTST MT_SELECT_TEST Selects Electrical Telecomm testing standard.
MTSY? MT_SYMBOL? Returns 1 or 0 symbol, or pos or neg.
MTTS MT_TEST_STATE Controls testing status: RUN, STOP, PAUSE, CONTINUE.
MTVA MT_VERTICAL_ALIGN Performs offset alignment for STM-1E, STS-3E, and 139M.
FUNCTION — T O P ERFORM W AVEFORM M ATHEMATICAL O PERATIONS
CLM CLEAR_MEMORY Clears the specified memory.
CLSW CLEAR_SWEEPS Restarts the cumulative processing functions.
DEF DEFINE Specifies math expression for function evaluation.
FCR FIND_CENTER_RANGE Automatically sets the center and width of a histogram.
FRST FUNCTION_RESET Resets a waveform processing function.
HARD COPY — T O P RINT THE C ONTENTS OF THE D ISPLAY
HCSU HARDCOPY_SETUP Configures the hard-copy driver.
SCDP SCREEN_DUMP Initiates a screen dump.
MISCELLANEOUS
ACAL AUTO_CALIBRATE Enables or disables automatic calibration
BUZZ BUZZER Controls the buzzer in the instrument.
*CAL? *CAL? Performs a complete internal calibration
COUT CAL_OUTPUT Sets the type of signal put out at the CAL connector.
DATE DATA Changes the date/time of the internal real-time clock.
DELF DELETE_FILE Deletes a file from the currently selected directory.
DIR DIRECTORY Creates or deletes directories, or changes the current directory.
MAIL EMAIL Sets up email protocol and addresses.
*IDN? *IDN? Used for identification purposes.
*OPT? *OPT? Identifies the installed oscilloscope options.
*TST? *TST? Performs internal self-test.
SAVE/RECALL SETUP — T O P RESERVE AND R ESTORE F RONT PANEL S ETTINGS
PNSU PANEL_SETUP Complements the *SAV/*RST commands.
*RCL *RCL Recalls one of five non-volatile panel setups.
RCPN RECALL_PANEL Recalls a front panel setup from mass storage.
*RST *RST Initiates a device reset.
*SAV *SAV Stores the current state in non-volatile internal memory.
STPN STORE_PANEL Stores the complete front panel setup on a mass-storage file.
STATUS — T O O BTAIN S TATUS I NFORMATION AND S ET U P S ERVICE R EQUESTS
ALST? ALL_STATUS? Reads and clears the contents of all (but one) of the status registers.
*CLS *CLS Clears all the status data registers.
CMR? CMR? Reads and clears the contents of the CoMmand error Register (CMR).
DDR? DDR? Reads and clears the Device-Dependent error Register (DDR).
*ESE *ESE Sets the standard Event Status Enable (ESE) register.