Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 204)

P A R T T W O : C O M M A N D S
198
ISSUED: February 2005 WM-RCM-E Rev D
CURSOR
PARAMETER_VALUE?, PAVA?
Query
DESCRIPTION The PARAMETER_VALUE query returns the current values of the
pulse waveform parameters and mask tests for the specified trace.
Traces do not need to be displayed or selected to obtain the values
measured by the pulse parameters or mask tests.
A VAILABLE ON A LL M ODELS
ALL
all parameters
FRST
First cursor position
POPATX
Population of bin at x
AMPL
Amplitude
FREQ
Frequency
RISE
Rise time 10% to 90 %
AREA
Area
HOLDLEV
Clock to data time
RISE28
Rise 20 % to 80 %
BASE
Base
LAST
Last cursor position
RLEV
Rise time at levels
CYCL
Cycles on screen
MAX
Maximum value
RMS
root mean square
DLY
Delay
MEAN
Mean value
SETUP
Data edge to clock
edge
DDLY Delta delay MEDI Median SDEV Standard deviation
DTLEV Delta time at level MIN Minimum value TLEV Time at level
DUR duration of acquisition PNTS Period TOP Top
DUTY duty cycle NULL phase difference WID Width
DULEV Duty cycle at level OVSN Overshoot negative WIDLV Width at level
EDLEV Edges at level OVSP Overshoot positive XMAX Pos of max data value
FALL82 Fall time 80 % to 20 % PKPK Peak to peak XMIN Pos if min data value
FALL
Fall time 90 % to 10 %
PER
Period
XAPK
Nth highest hist peak
FLEV
Fall at levels
PHASE
Phase difference
CUSTn
Custom parameter
C USTOM P ARAMETERS D EFINED USING PARAMETER_CUSTOM C OMMAND*
CUST1 CUST2 CUST3 CUST4 CUST5 CUST6 CUST7 CUST8
* The numbers in the terms CUST1 through CUST8 refer to the line numbers of the selected custom parameters.