Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 127)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
121
CURSORS
CURSORS, CRS
Command/Query
DESCRIPTION Sets the type of cursor to be used and the readout. Unlike CRMS,
this will not change the state of parameters or pass/fail.
COMMAND SYNTAX
CURSORS [,]
:=[OFF,HREL,HABS,VREL,VABS]
:=[ABS,SLOPE,DELTA] for HREL
:=[ABS,DELTA] for VREL
QUERY SYNTAX
CURSORS? or CRS?
EXAMPLE (GPIB) The following instruction sets the cursors to horizontal relative, and
readout to the difference between them.
CMD$=”CRS HREL,DELTA”:
CALL IBWRT(SCOPE%,CMD$)
RELATED COMMANDS CURSOR_MEASURE