Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 116)

P A R T T W O : C O M M A N D S
110
ISSUED: February 2005 WM-RCM-E Rev D
COMMUNICATION
COMM_HELP, CHLP
Command/Query
DESCRIPTION The COMM_HELP command controls the level of operation of the
diagnostics utility Remote Control Assistant, which assists in
debugging remote control programs. Selected using your
instrument's Utilities menu, Remote Control Assistant can log all
message transactions occurring between the external controller and
the oscilloscope (full dialog), or errors only. You can view the log at
any time on-screen and can choose from three levels:
OFF Don't assist at all.
EO Log detected Errors Only (default after power-on).
FD
Log the Full Dialog between the controller and the
oscilloscope.
COMMAND SYNTAX
Comm_HeLP
,
: = {OFF, EO, FD}
: = { NO,YES}
The default is EO.
If is set to YES (default), at power-on, the
logging level is set to EO and the log is cleared. If set to NO, the
user-set logging level is preserved and the log is not cleared.
Note: Setting CHLP EO, NO is useful in logging command
sequences that include rebooting the oscilloscope.
QUERY SYNTAX
Comm_HeLP?
RESPONSE FORMAT
Comm_HeLP
,
EXAMPLE (GPIB) After sending this command, all the following commands and
responses will be logged:
CMD$=“CHLP FD”: CALL IBWRT(SCOPE%,CMD$)
RELATED COMMANDS
COMM_HELP_LOG