Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 90)

P A R T T W O : C O M M A N D S
84
ISSUED: February 2005 WM-RCM-E Rev D
S HORT
F ORM
L ONG F ORM S UBSYSTEM
( CATEGORY )
W HAT THE C OMMAND OR Q UERY
D OES
DTJN DOT_JOIN DISPLAY Controls the interpolation lines between data points.
MAIL EMAIL MISCELLANEOUS Sets up email protocol and addresses.
*ESE *ESE STATUS
Sets the Standard Event Status Enable register
(ESE).
*ESR? *ESR? STATUS Reads, clears the Event Status Register (ESR).
EXR? EXR? STATUS Reads, clears the EXecution error Register (EXR).
FCR FIND_CENTER_RANGE FUNCTION
Automatically sets the center and width of a
histogram.
FRTR FORCE_TRIGGER ACQUISITION Forces the instrument to make one acquisition.
FRST FUNCTION_RESET FUNCTION Resets a waveform-processing function.
GRID GRID DISPLAY Specifies single-, dual- or quad-mode grid display.
HCSU HARDCOPY_SETUP HARD COPY Configures the hard-copy driver.
HMAG HOR_MAGNIFY DISPLAY Horizontally expands the selected expansion trace.
HPOS HOR_POSITION DISPLAY Horizontally positions intensified zone’s center.
*IDN? *IDN? MISCELLANEOUS For identification purposes.
INE INE STATUS Sets the INternal state change Enable register (INE).
INR? INR? STATUS Reads, clears INternal state change Register (INR).
INSP? INSPECT?
WAVEFORM
TRANSFER
Allows acquired waveform parts to be read.
ILVD INTERLEAVED ACQUISITION
Enables/disables Random Interleaved Sampling
(RIS).
INTS INTENSITY DISPLAY Controls the brightness of the grid.
IST? IST? STATUS Reads the current state of the IEEE 488.
MSG MESSAGE DISPLAY Displays a character string on the instrument screen.
MSIZ MEMORY_SIZE ACQUISITION Selects max. memory length.
MTAT MT_ATTENUATION ET-PMT
Sets cable attenuation factor for 2M_TP,
2M_COAX, 8M, 34M, 139M, 156M.
MTFA MT_FAIL_ACTION ET-PMT Sets fail actions.
MTOF MT_OFFSET ET-PMT Sets the offset for STM-1E, STS-3E, and 139M.
MTOP? MT_OPC? ET-PMT Returns state of last operation.
MTPC? MT_PF_COUNTERS? ET-PMT Returns pass/fail result.
MTST MT_SELECT_TEST ET-PMT Selects Electrical Telecomm testing standard.
MTSY? MT_SYMBOL? ET-PMT Returns 1 or 0 symbol, or pos or neg.
MTVA MT_VERTICAL_ALIGN ET-PMT
Performs offset alignment for STM-1E, STS-3E, and
139M.
OFST OFFSET ACQUISITION Allows output channel vertical offset adjustment.
OFCT OFFSET_CONSTANT CURSOR Sets offset to be fixed in either divisions or volts.
*OPC *OPC STATUS Sets the OPC bit in the Event Status Register (ESR).
*OPT? *OPT? MISCELLANEOUS Identifies oscilloscope options.
PNSU PANEL_SETUP SAVE/RECALL Complements the *SAV/*RST commands.
PARM PARAMETER CURSOR Controls the parameter mode.