Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 91)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
85
S HORT
F ORM
L ONG F ORM S UBSYSTEM
( CATEGORY )
W HAT THE C OMMAND OR Q UERY
D OES
PACL PARAMETER_CLR CURSOR Clears all current parameters in Custom, Pass/Fail.
PACU PARAMETER_CUSTOM CURSOR Controls parameters with customizable qualifiers.
PADL PARAMETER_DELETE CURSOR Deletes a specified parameter in Custom, Pass/Fail.
PAST? PARAMETER_STATISTICS? CURSOR Returns parameter statistics results.
PAVA? PARAMETER_VALUE? CURSOR Returns current parameter, mask test values.
PF PASS_FAIL CURSOR Sets up pass fail system.
PFDO PASS_FAIL_DO CURSOR Defines outcome and actions for Pass/Fail
PERS PERSIST DISPLAY Enables or disables the persistence display mode.
PECL PERSIST_COLOR DISPLAY
Controls color rendering method of persistence
traces.
PECS PER_CURSOR_SET CURSOR Positions one of the six independent cursors.
PELT PERSIST_LAST DISPLAY Shows the last trace drawn in a persistence data map.
PESA PERSIST_SAT DISPLAY Sets the color saturation level in persistence.
PESU PERSIST_SETUP DISPLAY Selects display persistence duration.
*PRE *PRE STATUS Sets the PaRallel poll Enable register (PRE).
*RCL *RCL SAVE/RECALL Recalls one of five non-volatile panel setups.
RCPN RECALL_PANEL SAVE/RECALL Recalls a front panel setup from mass storage.
RCLK REFERENCE_CLOCK SAVE/RECALL Toggles between internal clock and external clock.
*RST *RST SAVE/RECALL Initiates a device reset.
*SAV *SAV SAVE/RECALL Stores current state in non-volatile internal memory.
SCLK SAMPLE_CLOCK ACQUISITION Toggles between internal clock and external clock.
SCDP SCREEN_DUMP HARD COPY Initiates a screen dump.
SEQ SEQUENCE AQUISITION Controls the sequence mode of acquisition.
*SRE *SRE STATUS Sets the Service Request Enable register (SRE).
*STB? *STB? STATUS Reads the contents of the IEEE 488.
STOP STOP ACQUISITION Immediately stops signal acquisition.
STO STORE
WAVEFORM
TRANSFER
Stores a trace in internal memory or mass storage.
STPN STORE_PANEL SAVE/RECALL Stores front panel setup to mass storage.
STST STORE_SETUP
WAVEFORM
TRANSFER
Sets up waveform storage.
TDIV TIME_DIV ACQUISITION Modifies the timebase setting.
TMPL? TEMPLATE?
WAVEFORM
TRANSFER
Produces a complete waveform template copy.
TRA TRACE DISPLAY Enables or disables the display of a trace.
TRFL TRANSFER_FILE
WAVEFORM
TRANSFER Transfers ASCII files to and from storage media, or
between scope and computer.
*TRG *TRG ACQUISITION Executes an ARM command.
TRCP TRIG_COUPLING ACQUISITION
Sets the coupling mode of the specified trigger
source.
TRDL TRIG_DELAY ACQUISITION Sets the time at which the trigger is to occur.