Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 135)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
129
IFFT() Inverse FFT, real output from complex input
- INVERT Inversion (negation) of waveform.
INTG(),,,,
roffset>
INTRP(),, Interpolate extra points in waveform.
INTERPOLATETYPE IS LINEAR, QUADRATIC,
OR SINXX.
(-) INVERT Inversion (negation) of waveform
JITTERSIM
LN() Natural logarithm of waveform values
LOG10() Base 10 logarithm of waveform values
LPFIR
MCAD(,),,
var>,,,<
source2headervar>,,
Produces a waveform using Mathcad
MATLAB(,),,abplot>,, Produces a waveform using MATLAB
PERHIST(),,,orcutcenter>,,,, Histogram of a slice through a persistence map
PMEAN() Waveform derived from the mean of a persistence map
PRANGE(), Waveform derived from the range of a persistence map
PSIGMA(), Waveform derived from the st dev of a persistence map
PHSHIFT(), Change the phase of a set of complex data.
DESKEW(), RESAMPLE Shift a waveform in time.
RESC(),,,,
Rescale waveform as Out = A*Wave(In) + B
ROOF(), Highest Y value at each X in a set of waveforms
SEG(), Select one segment from a sequence
SINX() Ten times interpolation using sin (x) / x
SLICE(,),,
ds>,,
Slices waveform 2 to make many waveforms, using wf 1