Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 223)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
217
SAVE/RECALL SETUP
*RST
Command
DESCRIPTION The *RST command initiates a device reset. *RST sets all eight
traces to the GND line and recalls the default setup.
COMMAND SYNTAX
*RST
EXAMPLE (GPIB) The following instruction resets the oscilloscope:
CMD$=“*RST”: CALL IBWRT(SCOPE%,CMD$)
RELATED COMMANDS
*CAL, *RCL