Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 219)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
213
STATUS
*PRE
Command/Query
DESCRIPTION The *PRE command sets the PaRallel poll Enable register (PRE).
The lowest eight bits of the Parallel Poll Register (PPR) are
composed of the STB bits. *PRE allows you to specify which bit(s)
of the parallel poll register will affect the ‘ist’ individual status bit.
The *PRE? query reads the contents of the PRE register. The
response is a decimal number that corresponds to the binary sum of
the register bits.
COMMAND SYNTAX
PRE
: = 0 to 65 535
QUERY SYNTAX
*PRE?
RESPONSE FORMAT
*PRE
EXAMPLE (GPIB) The following instruction will cause the ‘ist’ status bit to become 1
as soon as the MAV bit (bit 4 of STB, i.e. decimal 16) is set, and
yields the PRE value 16:
CMD$=“*PRE 16”: CALL IBWRT(SCOPE%,CMD$)
RELATED COMMANDS
*IST