Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 43)

C H A P T E R T H R E E : Control by LAN
WM-RCM-E Rev D ISSUED: February 2005
37
3. If the TCP/IP protocol is not listed, you will have to add it. Follow your operating system user guide to
add the TCP/IP protocol and bind it to the Ethernet adapter.
4. Double-click the
line. A dialog box similar to the one below appears. Select
5. If this has already been selected, the computer’s static address is set and nothing more needs to be done.
Cancel out of the TCP/IP and network dialog boxes, and close the control panel.
6. If the address has not already been selected, fill in the IP address and subnet mask as shown above. The
subnet mask for 172.25.x.x is 255.255.0.0. If the computer will not be plugged into a network, the above