Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 190)

P A R T T W O : C O M M A N D S
184
ISSUED: February 2005 WM-RCM-E Rev D
CURSOR
PARAMETER_CUSTOM, PACU
Command/Query
DESCRIPTION The PARAMETER_CUSTOM command controls the parameters
that have customizable qualifiers and can also be used to assign any
parameter for histogramming.
NOTE: When PAVA? is used to query a Custom parameter,
the prefix is returned for consistency. However, the source for
the measurement is the one configured using the PACU
command.
TIP: Use
PAVA?
to read the measured value of a parameter
that was set up with
PACU
. To determine the correct form of a
PACU command in your scope model it is useful to set up the
scope manually to the configuration that you want, and then
send a PACU query. The response from the scope can be
copied straight into your program for use as a query.
COMMAND SYNTAX
Parameter_Custom
,,[,,...]
: = 1 to 8
: = {a parameter from the table below or any
parameter listed in the PAVA? command}
: = Measurement qualifier(s) specific to each .
See below.
C USTOMIZABLE P ARAMETERS ON ALL MODELS
Definition list
AMPL Amplitude
AREA Area
BASE Base
CYCL Cycles on screen
DLY Delay
DDLY Delta delay