Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 88)

P A R T T W O : C O M M A N D S
82
ISSUED: February 2005 WM-RCM-E Rev D
Example: consider the syntax notation for the command to set the vertical input sensitivity:
1. : VOLT_DIV
2. : = {C1, C2}
3. : = 5.0 mV to 2.5 V
The first line shows the formal appearance of the command: denotes the placeholder for the
header path; is the placeholder for the vertical gain value.
The second line indicates that either C1 or C2 must be chosen for the header path.
The third line means that the actual vertical gain can be set to any value from 5 mV to 2.5 V.