Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 238)

P A R T T W O : C O M M A N D S
232
ISSUED: February 2005 WM-RCM-E Rev D
ACQUISITION
TIME_DIV, TDIV
Command/Query
DESCRIPTION The TIME_DIV command modifies the timebase setting. The new
timebase setting can be specified with units: NS for nanoseconds,
US for microseconds, MS for milliseconds, S for seconds, or KS for
kiloseconds. Alternatively, you can use exponential notation: 10E-6,
for example. An out-of-range value causes the VAB bit (bit 2) in the
STB register (see table on page 225) to be set.
The TIME_DIV? query returns the current timebase setting.
COMMAND SYNTAX
Time_DIV
: = See the Operator’s Manual for specifications.
The unit S (seconds) is optional.
QUERY SYNTAX Time_DIV?
RESPONSE FORMAT
Time_DIV
EXAMPLE (GPIB) The following instruction sets the time base to 500 µs/div:
CMD$=“TDIV 500US”: CALL IBWRT(SCOPE%,CMD$)
The following instruction sets the time base to 2 msec/div:
CMD$=“TDIV 0.002”: CALL IBWRT(SCOPE%,CMD$)
RELATED COMMANDS
TRIG_DELAY, TRIG_MODE