Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 89)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
83
Table of Commands and Queries — By Short Form
S HORT
F ORM
L ONG F ORM S UBSYSTEM
( CATEGORY )
W HAT THE C OMMAND OR Q UERY
D OES
ALST? ALL_STATUS? STATUS Reads and clears the contents of all status registers.
ARM ARM_ACQUISITION ACQUISITION
Changes acquisition state from “stopped” to
“single.”
ASET AUTO_SETUP ACQUISITION Adjusts vertical, timebase and trigger parameters.
ATTN ATTENUATION ACQUISITION Selects the vertical attenuation factor of the probe.
ACAL AUTO_CALIBRATE MISCELLANEOUS Enables and disables automatic calibration
BUZZ BUZZER MISCELLANEOUS Controls the buzzer in the instrument.
BWL BANDWIDTH_LIMIT ACQUISITION Enables/disables bandwidth-limiting low-pass filter.
*CAL? *CAL? MISCELLANEOUS
Performs a complete internal calibration of the
DSO.
CFMT COMM_FORMAT COMMUNICATION Selects the format for sending waveform data.
CHDR COMM_HEADER COMMUNICATION Controls formatting of query responses.
CHLP COMM_HELP COMMUNICATION Controls operational level of the RC Assistant.
CHL COMM_HELP_LOG COMMUNICATION Returns the contents of the RC Assistant log.
CLM CLEAR_MEMORY FUNCTION Clears the specified memory.
*CLS *CLS STATUS Clears all status data registers.
CLSW CLEAR_SWEEPS FUNCTION Restarts the cumulative processing functions.
CMR? CMR? STATUS
Reads and clears the CoMmand error Register
(CMR).
COMB COMBINE_CHANNELS ACQUISITION Controls the channel interleaving function.
CORD COMM_ORDER COMMUNICATION Controls the byte order of waveform data transfers.
COUT CAL_OUTPUT MISCELLANEOUS Sets signal type put out at the CAL connector.
CPL COUPLING ACQUISITION Selects the specified input channel’s coupling mode.
CRMS CURSOR_MEASURE CURSOR Specifies the type of cursor/parameter measurement.
CRST CURSOR_SET CURSOR Allows positioning of any cursor.
CRVA? CURSOR_VALUE? CURSOR Returns trace values measured by specified cursors.
CRS CURSORS CURSOR Sets the cursor type.
CUAP CUSTOM_APPLICATION ET-PMT
Toggles between Mask Tester mode and
oscilloscope mode.
CU_OPT? CUSTOM_OPTIONS? ET-PMT Returns installed custom options.
DATE DATE MISCELLANEOUS
Changes the date/time of the internal real-time
clock.
DDR? DDR? STATUS
Reads, clears the Device Dependent Register
(DDR).
DEF DEFINE FUNCTION Specifies math expression for function evaluation.
DELF DELETE_FILE MISCELLANEOUS Deletes a file from the currently selected directory.
DIR DIRCTORY MISCELLANEOUS
Creates or deletes directories, or changes current
one.
DISP DISPLAY DISPLAY Controls the display screen.