Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 133)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
127
SWEEPS
Maximum number of sweeps
UNITS
Physical units
VERT
Vertical scaling type
WEIGHT
Continuous Average weight
WIDTH
Width of histogram display
WINDOW
FFT window function
F UNCTION E QUATIONS A ND N AMES
N N O O T T E E S S : : These functions are available according to the options installed in your X-Stream
oscilloscope. It can be very useful to run a function in query mode to determine whether it is available
in your oscilloscope, and to determine the current form of the command in your model. The
response to any query can be copied straight into a program and used as a command. Functions can
also be defined using the VBS command (see Chapter 6).
Underlined names in the left column of this table represent Boolean expressions, which take the
values ON and OFF.
- DIFFERENCE Difference of two waveforms
- INVERSION Inversion (negation) of waveform
* PRODUCT Product of two waveforms
/ RATIO Ratio of two waveforms
1/ RECIPROCAL Reciprocal of a waveform
+ SUM Sum of two waveforms
ABS() Absolute Value
AVG(),,,t>, AVERAGETYPE is SUMMED or CONTINUOUS.
BOXCAR(), Boxcar average with specified filter length
CORR(,),,> Correlation of two waveforms with specified correlation
length and start point
DERI(),,,ale> Derivative of waveform using subtraction of adjacent
samples
- DIFFERENCE Difference between two waveforms
DESKEW,(), Shift a waveform in time by a specified amount