Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 157)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
151
HARD COPY
HARDCOPY_SETUP, HCSU
Command/Query
DESCRIPTION The HARDCOPY_SETUP command configures the instrument’s hard
copy driver. It enables you to specify the device type and transmission
mode of the hard copy unit connected to the instrument. This can be
clipboard or disk drive as well as a printer. One or more individual
settings can be changed by specifying the appropriate keywords,
together with the new values. As with all multiple entry commands, you
can send any combination or permutation of keywords. If you send
contradictory values within a command, the result is governed by the
last one sent. See the following pages for command notation. Note that
some values are in quotation marks, because they are to be the names of
directories, files, or printers, which may contain spaces and other non-
alphanumeric characters. The other values must be chosen from the
lists provided below.
COMMAND SYNTAX
HardCopy_SetUp DEV, ,FORMAT,,
BCKG, ,DEST,””,DIR,””,
FILE,” ”,AREA,,PRINTER,”
rname>”
: = {PSD, BMP, BMPCOMP, JPEG, PNG, TIFF}
: = {PORTRAIT, LANDSCAPE}
: = {BLACK, WHITE}
: = {PRINTER, CLIPBOARD, EMAIL, FILE,
REMOTE}
: = valid destination directory name, for FILE mode only.
: = valid destination filename, auto incremented, for FILE
mode only.
:={GRIDAREAONLY, DSOWINDOW, FULLSCREEN}
: = {GPIB, RS232, NET} only accepted with a
command (for backward compatibility) and sets DEST, REMOTE.
: = valid printer name, for PRINTER mode only.