Part two: commands – Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control User Manual
Page 85
WM-RCM-E Rev D
ISSUED: February 2005
79
P
P
A
A
R
R
T
T
T
T
W
W
O
O
C
C
O
O
M
M
M
M
A
A
N
N
D
D
S
S
Part Two describes the commands and queries you will need to operate your
instrument remotely.
Important Note for users of other LeCroy instruments with existing remote control software.
Trace labels TA, TB, TC and TD have been replaced by traces F1, F2, F3 and F4, respectively. Existing
software that includes the old trace labels will work with X-Stream scopes, but new software should use the
new labels unless it will also be used on an earlier instrument. In addition to these four traces, the instrument
includes F5, F6, F7, and F8. Responses to queries will always use the new labels, even if the old labels are used
in the query, however. Traces F1 through F8 are completely equivalent in ability to perform zooms or
processing.
Parameter labels have also changed. These are now P1 through P8, but the older labels Cust1 through Cust5,
etc. will still work. Responses to queries will always use the new labels, even if the old labels are used.