Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 92)

P A R T T W O : C O M M A N D S
86
ISSUED: February 2005 WM-RCM-E Rev D
S HORT
F ORM
L ONG F ORM S UBSYSTEM
( CATEGORY )
W HAT THE C OMMAND OR Q UERY
D OES
TRLV TRIG_LEVEL ACQUISITION
Adjusts the trigger level of the specified trigger
source.
TRMD TRIG_MODE ACQUISITION Specifies the trigger mode.
TRPA TRIG_PATTERN ACQUISITION Defines a trigger pattern.
TRSE TRIG_SELECT ACQUISITION Selects the condition that will trigger acquisition.
TRSL TRIG_SLOPE ACQUISITION Sets the trigger slope of the specified trigger source.
*TST? *TST? MISCELLANEOUS Performs internal self-test.
VBS VBS AUTOMATION Sends an automation command
VDIV VOLT_DIV ACQUISITION Sets the vertical sensitivity.
VMAG VERT_MAGNIFY DISPLAY Vertically expands the specified trace.
VPOS VERT_POSITION DISPLAY Adjusts the vertical position of the specified trace.
*WAI *WAI STATUS WAIt to continue - required by the IEEE 488.
WAIT WAIT ACQUISITION Prevents new analysis until current is completed.
WF WAVEFORM
WAVEFORM
TRANSFER
Transfers a waveform from controller to scope.
WFSU WAVEFORM_SETUP
WAVEFORM
TRANSFER Specifies amount of waveform data to go to
controller.