Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 93)

Remote Control Commands and Queries
WM-RCM-E Rev D ISSUED: February 2005
87
Table of Commands and Queries — By Subsystem
S HORT
F ORM
L ONG F ORM W HAT THE C OMMAND OR Q UERY D OES
ACQUISITION — T O C ONTROL W AVEFORM C APTURE
ARM ARM_ACQUISITION Changes acquisition state from “stopped” to “single.”
ASET AUTO_SETUP Adjusts vertical, timebase and trigger parameters for signal display.
ATTN ATTENUATION Selects the vertical attenuation factor of the probe.
BWL BANDWIDTH_LIMIT Enables or disables the bandwidth-limiting low-pass filter.
COMB COMBINE_CHANNELS Controls the channel interleaving function.
CPL COUPLING Selects the specified input channel’s coupling mode.
FRTR FORCE_TRIGGER Forces the instrument to make one acquisition.
ILVD INTERLEAVED Enables or disables Random Interleaved Sampling (RIS).
MSIZ MEMORY_SIZE Allows selection of maximum memory length.
OFST OFFSET Allows vertical offset adjustment of the specified input channel.
RCLK REFERENCE_CLOCK Toggles between internal clock and external clock.
SCLK SAMPLE_CLOCK Toggles between internal clock and external clock.
SEQ SEQUENCE Controls the sequence mode of acquisition.
STOP STOP Immediately stops signal acquisition.
TDIV TIME_DIV Modifies the timebase setting.
*TRG *TRG Executes an ARM command.
TRCP TRIG_COUPLING Sets the coupling mode of the specified trigger source.
TRDL TRIG_DELAY Sets the time at which the trigger is to occur.
TRLV TRIG_LEVEL Adjusts the level of the specified trigger source.
TRMD TRIG_MODE Specifies Trigger mode.
TRPA TRIG_PATTERN Defines a trigger pattern.
TRSE TRIG_SELECT Selects the condition that will trigger acquisition.
TRSL TRIG_SLOPE Sets the slope of the specified trigger source.
VDIV VOLT_DIV Sets the vertical sensitivity in volts/div.
WAIT WAIT Prevents new command analysis until current acquisition completion.
AUTOMATION — T O S END A UTOMATION C OMMANDS
VBS VBS Send Automation commands.
COMMUNICATION — T O S ET C OMMUNICATION C HARACTERISTICS
CFMT COMM_FORMAT Selects the format to be used for sending waveform data.
CHDR COMM_HEADER Controls formatting of query responses.
CHLP COMM_HELP Controls operational level of the RC Assistant.
CHL COMM_HELP_LOG Returns the contents of the RC Assistant log.
CORD COMM_ORDER Controls the byte order of waveform data transfers.