Teledyne LeCroy X-STREAM OSCILLOSCOPES Remote Control - Manual (Page 120)

P A R T T W O : C O M M A N D S
114
ISSUED: February 2005 WM-RCM-E Rev D
CURSOR
CURSOR_MEASURE, CRMS
Command/Query
DESCRIPTION The CURSOR_MEASURE command specifies the type of cursor or
parameter measurement to be displayed, and is the main command
for displaying parameters and Pass/Fail.
The modes PARAM, SHOW DASH, and LIST used in some earlier
LeCroy instruments are not available in X-Stream instruments.
The CURSOR_MEASURE? query indicates which cursors or
parameter measurements are currently displayed.
N OTATION
CUST [,STAT] custom parameters
FAIL Pass/Fail: fail
HABS
horizontal absolute cursors
HPAR [,STAT] standard time parameters
HREL [,ABS,DELTA,SLOPE] horizontal relative cursors
OFF
cursors and parameters off
PASS Pass/Fail: pass
VABS vertical absolute cursors
VPAR [,STAT]
standard voltage parameters
VREL [,ABS,DELTA] vertical relative cursors
COMMAND SYNTAX
CuRsor_MeaSure [,]
: = {CUST, FAIL, HABS, HPAR, HREL, OFF, PASS,
VABS
, VPAR, VREL}
: = {STAT, ABS,DELTA,SLOPE}