beautypg.com

Fade to zero in, Fade to ‘half mute’ in, Start playing – Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual

Page 99: Whatever is next, Next higher soundfile, The same soundfile again, A random soundfile, Rate of fades

background image

c)! Fade to Zero In

This ramps the audio back towards the a fully muted level. The ‘In’ in the command refers to the time it

will take to ramp to the selected level. Ramp rates available are between 0 and 9.9 seconds.

d)! Fade to ʻHalf Muteʼ In

This ramps the audio towards the level which has been set for the ‘half muted’ level. The ‘In’ in the

command refers to the time it will take to ramp to the selected level. Ramp rates available are between 0
and 9.9 seconds. The audio level is set on the

Audio Setup

tab, or scaled from the RealTime level control, if

this option has been selected.

Start Playing

This series of popups allows you to select and play a SoundFile on this input/edge. The SoundFiles

can be selected from among all of those on the Sd/MMC flash card, or from one of the eight PlayLists:

Within the PlayList or Sd/MMC flash card you selected in the last step, you can select:

e)! Whatever is Next

This plays what the current/last SoundFile has set as the ‘next’ SoundFile to play at its end. This is set

on the

Track Setup

tab. This selection ignores the ‘on Sd/MMC flash card/From PlayList’ settings. As an

option, you can delay the start of the audio from 0 to 999.9 seconds (16.65 minutes) before it plays.

f)! Next Higher SoundFile

This plays the next SoundFile sequentially. This Setting is used to play SoundFiles ‘round robin’. You

can choose if the next track will be selected from all the SoundFiles loaded on the player, or from one of the
eight track lists. At the end of the list, the first track will be played again. As an option, you can delay the
start of the SoundFile from 0 to 999.9 seconds (16.65 minutes) before it plays.

g)! The Same SoundFile Again

The audio track which just played is started again. As an option, you can delay the start of the audio

from 0 to 999.9 seconds (16.65 minutes) before it plays.

h)! A Random SoundFile

This plays a SoundFile picked at random from the entire card or one of the eight track lists. As an op-

tion, you can delay the start of the audio from 0 to 999.9 seconds (16.65 minutes) before it plays.

Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Sd-50/xx Manual / October 29, 2012 2:29 PM / page 99 of 120