Stop commands, Stop track: “x” [nn] (card address), Stop global: “y – Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual
Page 60: Loop commands, Loop track: “!” [nn] (card address), Loop global, Stop at end commands, Stop at end track: “%” [nn] (card address), Stop at end global, Select show commands

played after a Sd-50/8 or Sd-50/40 is reset, it will play the show which has been set as the ‘first’ show dur-
ing the AutoDownload. Requests for specific shows can come only from the serial port.
When shows are downloaded to the Sd-50/8 or Sd-50/40, they can be set to ignore additional start
commands while they are playing. This allows individual shows to be ‘stepped’ upon or not. If the Sd-50/8
or Sd-50/40 is already playing a show which has this option set, it will ignore this command.
5) !
Stop Commands
!
!
Stop Track: “x” [nn] (card address)
!
!
Stop Global: “y”
These commands stop the selected Sd-50/8(s) or Sd-50/40(s) unconditionally. The stop takes place at
the current frame being played.
6) !
Loop Commands
!
!
Loop Track: “!” [nn] (card address)
!
!
Loop Global: ““”
These command acts much like the START commands, except that they also set the ‘LOOPING
SHOWS’ flag. With this flag set, it is possible to set a sequence of shows playing in any order. Since the
‘next’ show can be any show you ask for, one show can be played over and over again, or you can set up a
sequence of shows which will be repeated until the Sd-50/8 or Sd-50/40 is told to stop.
7) !
Stop at End Commands
!
!
Stop at End Track: “%” [nn] (card address)
!
!
Stop at End Global: “&”
These commands reset the ‘LOOPING SHOWS’ flag in the selected Sd-50/8 or Sd-50/40 (s). What this
does is to stop them playing when the end of the current show is reached. These commands are used
when you want the shows to finish gracefully. The STOP commands are used when you want to stop a
show immediately.
8) !
Select Show Commands
!
!
Select Show Track: “)” [nn] (Card Address) [nn] (show#)
!
!
Select Show Global: “*” [nn] (show#)
Up to two hundred fifty-five different animated shows can be stored on a single Sd-50/8 or Sd-50/40.
These commands can be used to select an individual show on the selected Sd-50/8 or Sd-50/40 (s). Indi-
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 60 of 120