Gilderfluke&Co Sd-50 Audio & Show Controllers - Manual (Page 111)

Sd-50/0, Sd-50/8, and Sd-50/40 Installation
The Sd-50/xx can be mounted using four screws; two DIN rail adapters; 2-3/4” Augat ‘Snap-Track’
(which itself can be DIN rail mounted using DIN rail adapters); or just Velcro’d down.
In many applications, the Sd-50/xx can be attached on (or in) the show or display it is controlling.
The Sd-50/xx must not be mounted where it might get wet, or suffer from extremes of temperature.
Unless the amplifier is being run at extreme output levels, the Sd-50/xx will generate very little heat.
Attaching it to something metal will allow it to dissipate what little heat it does generate.
If you are not using the amplifier, turn it off in the ‘Mp3 Config.exe’ program. The Sd-50/xx will gener-
ate less heat that way.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 111 of 120