Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual
Page 16

outputs are needed, additional Sd-50/8s or Sd-50/40s can be added to give you as many
outputs as you need.
• The digital
from a Sd-50/8 or Sd-50/40 can be fed to Digital to Analog
converters (like our single channel DAC-08 or four channel DAC-QUAD) wherever you need
0-10 volt analog control signals.
• When programming, or when installed as a permanent part of a larger control system, the Sd-
50/8 or Sd-50/40 accepts data through its
and
serial port. This data is used
to update the outputs, and takes precedence over the on board Flash memory.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 16 of 120