beautypg.com

Eeflag0, Play a sound, Stop sound – Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual

Page 77: Eeflag1, Eeflag2, Stop at end

background image

9) !

eeFlag0

These are the binary ‘flag’ settings from the ‘Mp3 Config.exe’ program. Valid values are from 00h to FFh. You

really shouldn’t muck with these. Following this line are the DMX/MIDI serial port settings. These are controlled by
the bits in eeFlag0. They will show:

bit0)

DMX-512

Rx: DMX-512 reception is enabled.

bit1)

MIDI in

Rx: MIDI reception is enabled.

bit2)

Net Serial

Rx: Net Serial reception is enabled.

bit3)

IR Mode

Rx: IR Mode reception is enabled.

a) !

Play a Sound

This command is available ONLY if SoundFiles have been found on the installed Sd/MMC

flash card.

This prompts you for a SoundFile number to play. It will only let you enter valid sound numbers. Once started,

the sound ‘info’ line will change to reflect the status of the sound file that was just started. If the sound file has been
configured to do a ‘seamless loop’ at the end, the ‘info’ line will report the sound as ‘looping’, instead of the more
usual ‘playing’.

b) !

Stop Sound

This command is available ONLY if SoundFiles have been found on the installed Sd/MMC

flash card.

This stops any sound which is playing immediately. If the sound which is playing is ‘unsteppable’, then using

this command to stop the sound will allow you to then start a new sound playing. Once stopped, the sound ‘info’ line
will change to reflect the status of the sound file.

c) !

eeFlag1

These are the binary ‘flag’ settings from the ‘Mp3 Config.exe’ program. Valid values are from 00h to FFh. You

really shouldn’t muck with these.

d) !

eeFlag2

These are the binary ‘flag’ settings from the ‘Mp3 Config.exe’ program. Valid values are from 00h to FFh. This

byte is currently unused. You really shouldn’t muck with these.

e) !

Stop at End

This command is available ONLY if ShowFiles have been loaded on the Sd-50/8 or Sd-50/

40.

This clears the ‘looping’ flag, so the currently running show (if any) will stop at the end and wait for the next start

command. Do NOT use this command for controlling the Sd-50/8 or Sd-50/40 except during testing. Use the
equivalent Serial Port command instead.

Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Sd-50/xx Manual / October 29, 2012 2:29 PM / page 77 of 120