Gilderfluke&Co Sd-50 Audio & Show Controllers - Manual (Page 63)

Serial Command Summary
Echo Commands:
Echo On:
“a” [nn] (card address)
Echo Off:
“b”
Card Status:
“i” [nn] (card address)
Card Reset:
“j5AA5” [nn] (card address)
Start Commands:
Start Track:
“t” [nn] (card address)
Start Global:
“u”
Stop Commands:
Stop Track:
“x” [nn] (card address)
Stop Global:
“y”
Loop Commands:
Loop Track:
“!” [nn] (card address)
Loop Global:
““”
Stop at End Commands:
Stop at End Track:
“%” [nn] (card address)
Stop at End Global:
“&”
Select Show Commands:
Select Show Track:
“)” [nn] (Card Address) [nn] (show#)
Select Show Global:
“*” [nn] (show#)
Select & Play Sound Commands:
Select Sound Track:
“^t” [nn] (Card Address) [nn] (sound#)
Select Sound Global:
“^u” [nn] (sound#)
Volume Command:
“^v” [nn] (Card Address) [vv] (Volume)
Show Pause Commands:
Pause Show:
“<” [nn] (card address)
Continue Show:
“>” [nn] (card address)
AutoDownload:
“sA5A5” [nn] (card address)
RealTime Update:
“~”
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 63 of 120