Do not change playback level, Fade to full in, Fade to zero in – Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual
Page 94: Fade to ‘half mute’ in, Start playing
a)! Do not change Playback Level
This option is not available if you are triggering a show with this input. This leaves the
audio levels where they were before.
b)! Fade to Full In
This option is not available if you are triggering a show with this input. This ramps the
audio towards the ‘full’ level. The ‘In’ in the command refers to the time it will take to ramp to the selected
level. Ramp rates available are between 0 and 9.9 seconds. The audio level is set on the
or by the RealTime level control, if this option has been selected.
c)! Fade to Zero In
This option is not available if you are triggering a show with this input. This ramps the
audio back towards the a fully muted level. The ‘In’ in the command refers to the time it will take to ramp to
the selected level. Ramp rates available are between 0 and 9.9 seconds.
d)! Fade to ʻHalf Muteʼ In
This option is not available if you are triggering a show with this input. This ramps the
audio towards the level which has been set for the ‘half muted’ level. The ‘In’ in the command refers to the
time it will take to ramp to the selected level. Ramp rates available are between 0 and 9.9 seconds. The
audio level is set on the
tab, or scaled from the RealTime level control, if this option has been
selected.
Start Playing
This series of popups allows you to select and play a Show or SoundFile on this input/edge. The
SoundFiles can be selected from among all of those on the Sd/MMC flash card, or from one of the eight
PlayLists (playlists are not available if you are triggering a show with this input.):
Within the PlayList or Sd/MMC flash card you selected in the last step, you can select:
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 94 of 120