Gilderfluke&Co Sd-50 Audio & Show Controllers - Manual (Page 95)

If you are triggering a show, the playlist popup is disabled and you can select:
e)! Whatever is Next
This plays what the current/last SoundFile has set as the ‘next’ SoundFile to play at its end. This is set
on the Track Setup tab. This selection ignores the ‘on Sd/MMC flash card/From PlayList’ settings. As an
option, you can delay the start of the audio from 0 to 999.9 seconds (16.65 minutes) before it plays.
f)! Next Higher Show or SoundFile
This plays the next Show or SoundFile sequentially. This Setting is used to play SoundFiles ‘round
robin’. You can choose if the next track will be selected from all the Shows or SoundFiles loaded on the
player, or from one of the eight track lists. At the end of the list, the first track will be played again. As an
option, you can delay the start of the Show or SoundFile from 0 to 999.9 seconds (16.65 minutes) before it
plays.
g)! The Same Show or SoundFile Again
The audio track which just played is started again. As an option, you can delay the start of the audio
from 0 to 999.9 seconds (16.65 minutes) before it plays.
h)! A Random Show or SoundFile
This plays a SoundFile picked at random from the entire card or one of the eight track lists. As an op-
tion, you can delay the start of the audio from 0 to 999.9 seconds (16.65 minutes) before it plays.
i)! Specific Show or SoundFile
This selects and plays a specific Show or SoundFile. This selection ignores the ‘on Sd/MMC flash card/
From PlayList’ settings. As an option, you can delay the start of the audio from 0 to 999.9 seconds (16.65
minutes) before it plays.
Stop Playing
This popup allows you to stop a SoundFile playing on this input/edge.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 95 of 120