Verify shows, Exit, Set time zone – Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual
Page 74

v) !
Verify Shows
This command is available ONLY if ShowFiles have been loaded on the Sd-50/8 or Sd-50/
40.
This command is used to test the show data which has been downloaded to the Sd-50/8 or Sd-50/40. This will
take anywhere from a few seconds to several minutes, depending of the size of the AutoDownload file that must be
tested. It you have the ‘Atomic’ Clock option installed in your Sd-50/8 or Sd-50/40, it will give you the option of
verifying the schedule or shows, if both have been downloaded, If no shows have been downloaded, but a schedule
file has, then this command will automatically verify the schedule.
x) !
Exit
This is used to exit the configuration mode. It will ask you to press ‘y’ or ‘n’ before completing the command.
z) !
Set Time Zone
This command is used to offset how much time must be added or subtracted from the Universal Coordinated
Time (UCT, also known as ‘Zulu’ time) to display the local time. You can set whether time is added or subtracted
from UCT for the local ‘standard’ time and the number of hours (valid numbers are 0 through 15). For those few
places in the world that need it, you can also set the number of minutes to add at 0, 15, 30 or 45 minutes on top of
the number of hours to be added/subtracted.
The amount of time should be set to offset to ‘standard’ time wherever you are. Do not offset to DST! The DST
rules will take care of the Daylight Savings Time for you.
Pacific Standard time is -8:00.
Mountain Standard Time is -7:00.
Central Standard Time is -6:00.
Eastern Standard Time is -5:00.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 74 of 120