An sis, Audio follow, An sis command (see the – Extron Electronics DVS 510 Series User Guide User Manual
Page 68: User presets, Commands in the command and response t, Audio mute
DVS 510 Series • Remote Configuration and Control
62
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Audio Commands (continued)
Limit Audio Level on Power-up
Set power-up limit
E
X5)
ALMT
}
Almt
X5)
]
Set the maximum volume level at
power-up to
X5)
.
View setting
E
ALMT
}
X5)
]
Show the current power-up volume limit.
Audio Input Format (for embedded digital audio source)
Set digital 2-channel
audio
E
I
2
AFMT
}
Afmt
I
2
]
Select digital 2-channel audio EDID
(default).
Set full digital audio
E
I
3
AFMT
}
Afmt
I
3
]
Select full digital audio EDID.
View
E
I
AFMT
}
X5*
]
Show selected digital audio EDID type.
Audio Output Format
Set format
E
O
X5!
AFMT
}
Afmt
O
X5!
]
Select variable and amplified output
signal format
X5!
.
View
E
O
AFMT
}
X5!
]
Show selected audio output format.
Audio Mute
Enable mute
1
Z
Amt1
]
Mute the current input.
Disable mute
0
Z
Amt0
]
Unmute the current input.
View mute status
Z
X1)
]
Show the mute status. For
X1)
:
0 = mute off, 1 = mute on.
Audio Delay
Enable audio delay
E
1
ADLY
}
Adly
1
]
Enable audio delay to compensate for the
time needed to process the input signal.
Disable audio delay
E
0
ADLY
}
Adly
0
]
Disable audio delay.
View
E
ADLY
}
X1)
]
Show the status of audio delay. For
X1)
:
0 = audio delay disabled
1 = audio delay enabled
Audio Follow
Set audio follow
E
X5&
AFLW
}
Aflw
X5&
]
Select source
X5&
for the audio.
View
E
AFLW
}
X5&
]
Show the current audio source.
Presets
User Presets
Recall user preset
1
*
X2%
.
1
Rpr
X2%
]
Recall user preset
X2%
for selected input.
Save user preset
1
*
X2%
,
1
Spr
X2%
]
Save user preset
X2%
for the selected
input (see “
” on page 53
for the saved parameters).
NOTE: X1)
= Audio mute or delay status
0 = unmuted or disabled, 1 = muted or enabled
X2%
= User preset number
1 through 16
X5)
= Audio volume level
0 through 100
X5!
= Audio format
1 = mono, 2 = stereo
X5&
= Audio source
0 = follow main window, 1 = follow PIP window
X5*
= Digital audio input type
2 = digital, 2-channel LPCM 48 kHz (default)
3 = digital full audio (7.1, DTS, and so on)