Input presets, Audio functions, Input presets audio functions – Extron Electronics DVS 510 Series User Guide User Manual
Page 44
DVS 510 Series • Operation
38
Input Presets
The DVS 510 Series has 128 input preset slots, which can save signal type, input
configuration settings, and picture control settings for any of the inputs. These presets can
be saved and recalled using the Windows-based control software (see the Signal Processing
Products Control Program help file), SIS commands (see the
commands on
page 63 in the Command and Response Table for SIS Commands) or the DVS 510 Series
web pages (see “
” on page 102).
The following settings are contained in the input presets:
•
Input Type
•
Color
•
Horizontal Start
•
Horizontal Position
•
Preset Name*
•
Tint
•
Vertical Start
•
Vertical Position
•
Film Mode Detect
•
Contrast
•
Pixel Phase
•
Horizontal size
•
Zoom
•
Brightness
•
Total Pixels
•
Vertical size
•
Pan
•
Detail Filter
*Can be set by SIS command only.
The 128 input presets are global, containing all of the settings for an input when the DVS is
used with a matrix switcher. This allows a matrix switcher with multiple types of video inputs
to be connected to the DVS 510 to expand the number of input video sources.
Each input should be switched into the DVS, configured, then saved as a preset for recall
by a control system when that input is sent from the matrix switcher to any of the 10 DVS
inputs.
•
If an input preset is recalled to an input that does not support the input type saved in
the preset, an SIS error code is returned.
•
If the signal frequencies and total line count do not match the frequencies saved in the
preset, the DVS uses the auto memories settings instead of recalling the preset. If no
auto memory exists for the frequency, the DVS references its lookup table (a generic list
of default sampling parameters embedded in the DVS).
•
If the output rate does not match the output rate that was active when the preset was
saved, all settings in the input preset are recalled except size and position.
Audio Functions
The DVS 510 Series provides three audio outputs: fixed, variable, and amplified (DVS 510 SA
only). The following table shows the functions available on these audio outputs.
Function
Fixed Output
Variable Output
Amplified Output
Bass
X
X
Treble
X
X
Volume Level
X
X
Gain or Attenuation
X
X
X
Limiter
X
Audio Delay
X
X
X
” on page 28 for information on adjustments to the
functions listed in the table above.)