Video mute – Extron Electronics DVS 510 Series User Guide User Manual
Page 63
DVS 510 Series • Remote Configuration and Control
57
Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Active Lines
Specify a value
E
X(
ALIN
}
Alin
X!
*
X(
]
Adjust the active lines value to
X(
.
Increment value
E
+
ALIN
}
Alin
X!
*
X(
]
Increase the number of active lines.
Decrement value
E
–
ALIN
}
Alin
X!
*
X(
]
Decrease the number of active lines.
View active lines
E
ALIN
}
X(
]
Show the number of active lines.
Film Mode Detect (3:2 pulldown detection)
Enable
E
X!
*
1
FILM
}
Film
X!
*
X1)
]
Enable Film mode detection (auto sense
for 3:2 or 2:2 pulldown) for input
X!
.
Disable
E
X!
*
0
FILM
}
Film
X!
*
X1)
]
Disables Film mode detect for input
X!
.
View setting
E
X!
FILM
}
X1)
]
View the current film mode detect
setting. For
X1)
:
0 = Film mode detection off.
1 = film mode detection on.
Video Mute
Mute video to black
1B
Vmt1
]
Mute the video and display a black
screen.
Mute video and sync
2B
Vmt2
]
Mute the video and sync on all outputs.
Unmute video and sync
0B
Vmt0
]
Disable all mutes.
View mute status
B
X4@
]
View mute status
X4@
.
Picture Controls
Color (available for NTSC composite and S-video only)
Specific value
E
X1%
COLR
}
Colr
X!
*
X1%
]
Set the color level to
X1%
.
Increment up
E
+
COLR
}
Colr
X!
*
X1%
]
Select the next higher color level.
Increment down
E
–
COLR
}
Colr
X!
*
X1%
]
Select the next lower color level.
View color setting
E
COLR
}
X1%
]
View the current color setting.
Tint (available for NTSC composite and S-video only)
Specific value
E
X1%
TINT
}
Tint
X!
*
X1%
]
Set the tint level to
X1%
.
Increment up
E
+
TINT
}
Tint
X!
*
X1%]
Select the next higher tint level.
Increment down
E
–
TINT
}
Tint
X!
*
X1%
]
Select the next lower tint level.
View tint setting
E
TINT
}
X1%
]
View the current tint setting.
NOTE: X!
= Input selection
1 through 10
X(
= Active lines
±256 of the default value
X1)
= On and off
0 = off, 1 = on
X1%
= Picture adjustments
0 through 127 (for color, tint, contrast, brightness, and detail filter)
X4@
= Video mute status
0 = unmuted, 1 = muted to black screen, 2 = all output video and sync
muted