Extron Electronics DVS 510 Series User Guide User Manual

Page 31

DVS 510 Series • Operation

Input Configuration Submenu

Horizontal ([) and Vertical Knob ({) Adjustment

Video Signal Type (Inputs 5, 6, 7, and 9)
Accepted video signal types include RGB, RGBcvS,
YUVp/HDTV, and YUVi.

Select the desired video format for the selected input
(this adjustment is available only for inputs 5, 6, 7, and
9). The default is

RGB

Film Mode Detect
Enable and disable 3:2 pulldown detection for NTSC and
2:2 film detection for PAL video sources.
3:2 and 2:2 pulldown (film modes) help maximize image
detail and sharpness for video sources that originated
from film. When film is converted to NTSC video, the
film frame rate must be matched to the video frame
rate. “Jaggies” and other image artifacts can result if
conventional de-interlacing techniques are used on film-
source video.
When film mode is enabled, the DVS recognizes
signals that originated from film and then applies video
processing algorithms that optimize the conversion
of video that was made with the 3:2 or 2:2 pulldown
process. This results in sharply detailed images.

Select

Off

to turn 3:2 or 2:2 pulldown (film mode)

detection on and off for the selected input. The default
is

Off

Vertical Start Position
The distance in pixels from the top edge of the total
video display area for the selected input to the top edge
of its active area

Select the vertical start position. The default is

128

Horizontal Start Position
The distance in pixels from the left edge of the total
video display area for the selected input to the left edge
of its active area

Select the horizontal start position. The default is

128

Pixel Phase (Inputs 5, 6, 7, and 9)
The point at which pixels are sampled (available only for
RGB and YUVp/HDTV inputs)

Select the amount to move the pixel sampling point
to ensure output clarity. The range of settings is

;

default is

Total Pixels (Inputs 5, 6, 7, and 9)
The width in pixels of the total video display area
(available only for RGB and YUVp/HDTV inputs)

Select the width in pixels of the total video display area
for the selected input. The default width is marked with
an asterisk (*) on the LCD screen.

Active Pixels
The width in pixels of the active video area

Select the width in pixels of the active video area for
the selected input. The default width is marked with an
asterisk (*) on the LCD screen.

Active Lines
The height in lines of the active video area

Select the height in lines of the active video area of the
selected input. The default width is marked with an
asterisk (*) on the LCD screen.

EDID (Extended Display Identification Data)
(Inputs 5, 6, 8, and 10)
The resolution and refresh rate of a display device
(available only for RGB and DVI inputs)

NOTE:

This submenu is not displayed when

input 1-4, 7, or 9 is selected.

Select an EDID to apply to the selected input.

•

The Horizontal ([) Adjust knob selects the
resolution.

•

The Vertical ({) Adjust knob selects the refresh rate.