Extron Electronics DVS 510 Series User Guide - Manual (Page 40)

DVS 510 Series • Operation 34
View Comm Settings Menu
The View Comm Settings menu lets you view the current settings for the communication
ports, including the IP, subnet mask, and gateway addresses of the unit, the MAC (Media
Access Code or hardware) address, the Dynamic Host Configuration Protocol (DHCP) status,
and the serial port baud rate and type.
NOTE: None of the settings can be changed from this menu; to make adjustments, use
the Edit Comm Settings menu (see “ Edit Comm Settings Menu ”).
The flow diagram below shows the screens and the settings that can be viewed from this
menu.
View Comm
Settings
Serial Port
9600 RS232
MAC Address
0005A605CDC7
DHCP Mode
Off
Next Next
Next
Advanced
Configuration
Menu
Serial Port
View baud rate and port
protocol.
MAC Address
View Media Access Code
(MAC) hardware address.
IP Address
192.168.254.254
Next
Next
IP Address
View unit IP address.
Gateway Address
000.000.000.000
Gateway Address
View gateway IP address.
DHCP Mode
View Dynamic Host
Configuration Protocol
(DHCP) On/Off status.
Subnet Mask
255.255.000.000
Subnet Mask
View subnet mask IP address.
Next Next
Figure 20. View Comm Settings Menu
Edit Comm Settings Menu
This menu lets you make changes to the serial port configuration, IP addresses, and the
DHCP mode. Although the Edit Comm Settings menu has almost all the same screens as the
View Comm Settings menu, it is accessed differently.
NOTE: You can access the Edit Comm Settings menu from any other menu or from the
default cycle.
To display the Edit Comm Settings menu:
1. Press and hold the Next button.
2. While holding the Next button, press the Detail and Color/Tint buttons simultaneously.
3. Hold all three buttons until the Edit Comm Settings screen is displayed (approximately
2 seconds).
If no activity occurs within 30 seconds, the DVS saves all settings and returns to the default
cycle.