Extron Electronics DVS 510 Series User Guide User Manual
Page 108
DVS 510 Series • HTML Configuration and Control 102
•
Pixel Phase (RGB and YUVp/HDTV inputs only): Adjust the point at which pixels are
sampled for the selected input. The range is
1
through
31
; the default is
16
.
•
Total Pixels (RGB and YUVp/HDTV inputs only): Increase or decrease the width in
pixels of the total line of video. The default is the auto-sensed value. The range is ±512
from the auto-sensed value.
•
Active Pixels: Increase or decrease the width in pixels of the active video area of
the selected input. The default is the auto-sensed value. The range is ±512 from the
auto-sensed value.
•
Active Lines: Increase or decrease the height in lines of the active video area of the
selected input. The default is the auto-sensed value. The range is ±512 from the
auto-sensed value.
Memory/Input Presets Page
On the Presets page, you can save and recall user (memory) and input presets.
Figure 50.
Memory/Input Presets Page
User (memory) presets
User presets save the current set of image parameters for the currently selected input. Each
input has 16 available user presets to which you can save settings. You can subsequently
recall any of the saved presets to replace the current configuration. The following
parameters are saved in a user preset:
•
Color
•
Horizontal position
•
Tint
•
Vertical position
•
Contrast
•
Horizontal size
•
Brightness
•
Vertical size
•
Detail
•
Pan
•
Zoom
To create a user preset:
1.
Click the
User
Control
link on the left sidebar menu to display the User Control page.
2.
In the Input Selection section, click the button for the input for which you want to
create the preset.
3.
Make any desired changes to the picture and input sampling controls and other
attributes for your chosen input.