Extron Electronics DVS 510 Series User Guide - Manual (Page 41)

DVS 510 Series • Operation 35
The flow diagram below shows the Edit Comm Settings screens and the adjustments that
are available from them.
Next
Serial Config
9600 RS232
Next
Set DHCP Mode
Off
Next
Set the DHCP mode:
• Off (Default)
• On
Set IP Address
192.168.254.254
Next
Next
Edit Comm
Settings
Press and hold
Next + [Detail+Color/Tint].
Select the baud rate:
• 9600 (Default)
• 19200
• 38400
• 115200
Select the serial
communication type:
• RS232
• RS422
Next
Select an octet. Increase or decrease
selected number:
• Range: 000 through 255
(each octet)
• Default: 192.168.254.254
Set the IP Address:
Set Gateway Addr
000.000.000.000
Select an octet. Increase or decrease the
selected number:
• Range: 000 through 255
(each octet)
• Default: 000.000.000.000
Set the Gateway Address:
Set Subnet Mask
255.255.000.000
Select an octet. Increase or decrease the
selected number:
• Range: 000 through 255
(each octet)
• Default: 255.255.000.000
Set the Subnet Mask:
2 Sec.
Figure 21. Edit Comm Settings Menu
Adjustments can be made via the following Edit Comm Settings screens:
Serial Configuration submenu
1. Press Next until the Serial Configuration screen is displayed.
2. Rotate the horizontal Adjust knob ([) to select the baud rate. The available selections
are
9600 (the default), 19200 , 38400 , and 115200 .
Rotate the vertical Adjust knob ({) to select RS232 or RS422 .
Set DHCP Mode submenu
When Dynamic Host Configuration Protocol (DHCP) mode is enabled, the scaler ignores any
entered IP address and obtains its IP address from a DHCP server (if the network is DHCP
capable).
On the Set DHCP Mode screen, rotate either Adjust knob to the right to turn DHCP on or to
the left to turn DHCP off. Contact your system administrator for the setting to select.