Extron Electronics DVS 510 Series User Guide - Manual (Page 15)

DVS 510 Series • Installation 9
f
RGB/YUV output connectors — Connect cables from RGB (RGBHV, RGBS, RGsB) or
YUVp/HD component (R-Y, Y, B-Y) display devices to these female 15-pin HD connectors
for scaled RGB or component video output. The output can be scaled to 69 different
output rates (see the
resolution and refresh rates table on page 27).
NOTE: Outputs are buffered and can be connected simultaneously to two different
displays. The sync and video formats are the same for all outputs.
g
DVI-I output connector — Connect a digital (DVI-D) display device to this DVI-I
connector for a scaled DVI output (analog output is not available on this connector). The
figure below shows the pin assignments for the DVI output connector.
8 Not used 16 Hot plug detect 24 TMDS clock–
Pin Signal Pin Signal Pin Signal
1 TMDS data 2– 9 TMDS data 1– 17 TMDS data 0–
2 TMDS data 2+ 10 TMDS data 1+ 18 TMDS data 0+
3 Ground (2/4 ) 11 Ground (1/3) 19 Ground (0/5)
4 Not used 12 Not used 20 Not used
5 Not used 13 Not used 21 Not used
6 DDC clock 14 +5 V power 22 Ground (clock)
7 DDC data 15 Ground (for 5 V) 23 TMDS clock+
1 8
17 24 9
h
Audio input connectors — Connect up to 10 audio input devices to these female
3.5 mm 5-pole captive screw connectors for balanced or unbalanced audio input. (One
audio input is provided for each video input.)
Do not tin the wires! Balanced Stereo Input
Tip
Ring
Tip
Ring
Sleeves
LR
Unbalanced Stereo Input
Tip
Sleeve
Sleeve
Tip
LR
Figure 4. Audio Input Connector Wiring
i
Amplified audio output connector (DVS 510 SA only) — This 4-pole, 5 mm captive
screw connector enables you to connect a set of speakers or another output device to
the DVS 510 SA internal amplifier for amplified output.
All right channel input signals are mixed and summed to produce a single, right channel
output; likewise, all left channel input signals are mixed and summed to produce a
single, left channel output.
If
Stereo is selected for the output type, the output is stereo; if Dual Mono is selected,
the right and left channels are mixed and summed for a dual mono output.
With an 8 ohm load, the amplifier produces up to 8 watts per channel. With a 4 ohm
load, the amplifier produces up to 25 watts per channel.
(See “
Wiring the Amplified Audio Port [DVS 510 SA Only] ”on page 12 for
information on connecting speakers to this port.)