Symbol definitions for dvs 510 series sis commands, Symbol definitions for dvs 510 series sis, Commands – Extron Electronics DVS 510 Series User Guide User Manual
Page 57
DVS 510 Series • Remote Configuration and Control
51
ASCII to Hex Conversion Table
•
Space
Figure 28.
ASCII to Hexadecimal Character Conversion Table
NOTE: Upper- and lowercase text can be used interchangeably except where noted.
Symbol Definitions for DVS 510 Series SIS Commands
•
=
Space
]
=
Carriage return with line feed
}
=
Carriage return with no line feed
|
=
Pipe (vertical bar) character. For URL-encoded commands, has the same function as
}
.
E
=
Escape
W
=
For URL-encoded commands, has the same function as
E
14, 24, 27, 28
= Superscripts indicate the error message displayed if the command is entered
incorrectly or with invalid parameters (see “
previous page).
X!
= Input selection
1 through 10
X@
= Output selection
1 = DVI
2 = Top VGA connector
3 = Bottom VGA connector
X#
= Input video format
1 = RGB
5 = S-video
2 = YUVp/HDTV 6 = Composite
3 = RGBcvS
7 = DVI
4 = YUVi
X$
= H start
0 through 255
X%
= V start
0 through 255
X^
= Pixel phase
0 through 31
X&
= Total pixels (±512 of default
value for high resolution video
and ±256 of the default value for
low resolution video)
X*
= Active pixels (±512 of the default
value for high resolution video
and ±256 of the default value for
low resolution video)
X(
= Active lines (±256 of default value)
X1)
= On and off
0 = Off or disable
1 = On or enable
X1!
= Input standard
0 = No signal
3 = NTSC 4.43
1 = NTSC 3.58
4 = SECAM
2 = PAL
– = Not applicable (occurs when input is set to RGB or
YUVp/HDTV)
X1@
= Internal temperature (in degrees Celsius)