Extron Electronics DVS 510 Series User Guide - Manual (Page 10)

DVS 510 Series • Introduction 4
• Test patterns — 12 test patterns are provided for calibration and setup, including a
crop pattern, crosshatch, 16 bar grayscale, color bars, alternating pixels, ramp, white
field, 4 x 4 crosshatch, and four aspect ratio patterns (1.33, 1.78, 1.85, and 2.35).
• Front panel security lockout (executive mode) — When enabled, locks out all front
panel functions except for input selection (all functions remain available through RS-232,
RS-422, or IR remote control).
• Optional IR remote control — The optional Extron IR 904 handheld remote control
provides an additional method of input source switching, picture-in-picture, and direct
access to picture adjustments.
• Ethernet monitoring and control — The DVS 510 can be controlled and proactively
monitored over a LAN, WAN, or the Internet. Embedded web pages are included for
such common functions as input switching, volume control, and system configuration.
• RS-232 and RS-422 control — The DVS 510 can be controlled and configured via
Simple Instruction Set (SIS™) commands, a set of basic ASCII code commands that allow
for quick and easy programming via RS-232 or RS-422.
• Windows-based configuration and control software — The Signal Processing
Products Control Program (SPPCP) can be used to configure and control the DVS 510 via
RS-232, RS-422, or Ethernet.
• Rack-mountable 2U, full rack width metal enclosure
• Internal universal power supply — The 100-240 VAC, 50-60 Hz, international power
supply provides worldwide power compatibility.
Controlling the DVS 510 Series
You can control the DVS 510 and the DVS 510 SA using one or more of the following
methods:
• The front panel controls include back-lit buttons, a Volume Control knob, and rotary
Adjustment encoders.
• A computer, a touch screen panel, or any other device that can send and receive serial
communications through the RS-232/RS-422 or Ethernet port enables the following
controls:
• The Extron Simple Instruction Set (SIS) is a set of simple keystroke commands that
can be used with any RS-232 or RS-422 device.
• The Extron Windows-based control software provides a graphical interface for
controlling the scaler from a computer.
• The embedded web pages enable HTML control of the DVS from a computer.
• The optional IR 904 remote control, part number 70-767-01, replicates most of the front
panel controls