Extron Electronics DVS 510 Series User Guide - Manual (Page 115)

DVS 510 Series • Reference Information 109
Audio output
Number/signal type ........................ 1 stereo or 2 mono (2 channels total)
Connectors .................................... (2) 3.5 mm captive screw connectors, 5-pole
Impedance ..................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.25 dB channel to channel
Maximum level (Hi-Z) ...................... >+21 dBu, balanced at 1% THD+N
>+11 dBu, unbalanced at 1% THD+N
Maximum level (600 ohm) .............. >+14 dBm, balanced at 1% THD+N
>+10 dBm, unbalanced at 1% THD+N
Audio output — amplified — DVS 510 SA only
Number/signal type ........................ 1 stereo or 2 mono (2 channels total)
Connectors .................................... (1) 5 mm captive screw, 4-pole
Load impedance ............................. 2 ohms, minimum
Amplifier type ................................ Class D
Output power ................................ 25 watts rms per channel, 2/4/8 ohms, 1 kHz, 1% THD
Frequency response ........................ 20 Hz to 20 kHz, ±3 dB
THD + Noise ................................... 0.15% @ 1 kHz at nominal level (1 watt, 8 ohm load)
S/N ................................................. 74 dB, 20 Hz to 20 kHz, unweighted
Control/remote — decoder/scaler
Serial control port ........................... 1 rear panel female 9-pin D connector, RS-232/RS-422
1 front panel 2.5 mm stereo mini jack, RS-232
Baud rate and protocol ................... 9600, 8 data bits, 1 stop bit, no parity, no flow control
Serial control pin configurations
9-pin D connector .................... RS-232: 2 = Tx, 3 = Rx, 5 = GND
RS-422: 2 = Tx-, 3 = RX-, 5 = GND, 7 = RX+, 8 = Tx+
Mini stereo jack ....................... RS-232: tip = Tx, ring = Rx, sleeve = GND
Ethernet control port ...................... 1 RJ-45 female
Ethernet data rate .......................... 10/100Base-T, half/full duplex with auto-detect
Ethernet protocol ........................... ARP, ICMP (ping), IP, TCP, DHCP, HTTP, SMTP, Telnet
Ethernet default settings ................ Link speed and duplex level = auto-detected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Default gateway = 0.0.0.0
DHCP = off
Web server ..................................... Up to 200 simultaneous sessions
8 MB nonvolatile user memory
IR remote control ........................... IR 904 (optional)
30' maximum, 40 degrees off axis
Program control ............................. Extron control/configuration software for Windows ®
Extron Simple Instruction Set (SIS ™ )
Microsoft ® Internet Explorer ® ver. 6 or higher, Telnet
General
Power Supply ................................. Internal
Input: 100-240 VAC, 50-60 Hz
Power consumption
DVS 510 .................................. 28 watts
DVS 510 SA ............................. 71 watts
Temperature/humidity .................... Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling .......................................... Fan, right to left as viewed from front panel
Thermal dissipation
DVS 510 .................................. 90 BTU/hr
DVS 510 SA ............................. 132 BTU/hr