Extron Electronics DVS 510 Series User Guide - Manual (Page 34)

DVS 510 Series • Operation 28
Audio Configuration Menu
The Audio Configuration menu enables you to adjust the levels of gain, attenuation, bass,
and treble; enable and disable the limiter for the amplifier (DVS 510 SA only); turn audio
delay on and off; and select the audio output type (stereo or dual mono). The flow diagram
below shows the Audio Configuration submenus and the adjustments that can be made
from them.
NOTE: The volume of the Variable output can be adjusted via the DVS front panel
Volume knob (see Volume Control on page 39), SIS commands (see the Audio
Volume commands on page 61 in the Command and Response Table for SIS
Commands) or the Signal Processing Products Control Program (see the control
program help file).
Audio
Configuration
Gain/Attenuation
0 dB
Bass
0 dB Treble
0 dB
Next Next
Next
Output
Configuration
Menu
Gain /Attenuation
Set the audio gain or
attenuation for the
selected input.
• Range: -12 through +12
• Default: 0
Bass
Set the bass level.
• Range: -12 through +12
• Default: 0
Audio Output
Stereo
Next
Next
Audio Output
Select the audio output type.
• Stereo (Default)
• Dual Mono
Limiter
On
Limiter*
Set the limiter to On or Off.
• On: Automatically
reduces audio level
to prevent clipping.
• Off (default)
Treble
Set the treble level.
• Range: -12 through +12
• Default: 0
*This submenu appears only
on the DVS 510 SA.
Audio Delay
On
Audio Delay
Set audio delay to On or Off.
• On: Delays the audio to
match the video delay
(default).
• Off
Next Next
Use either Adjust knob to
select a submenu option.
Figure 17. Audio Configuration Menu
Gain/Attenuation submenu
To set the gain and attenuation levels from this submenu, rotate either Adjust knob to the
right to select the gain (
0 through +12 ) and to the left to select the attenuation ( 0 through
-12 ). The default is 0 .
Bass and Treble submenus
To increase or decrease the bass and treble levels:
1. Press Next until the desired submenu ( Bass or Treble ) is displayed.
2. Rotate either the Adjust knob right to increase or left to decrease the level of bass or
treble.
The range for bass and treble is -12 through +12 ; the default is 0 .
Limiter submenu (DVS 510 SA only)
The Limiter submenu is displayed only on the DVS 510 SA. When enabled, the limiter
reduces the amplifier level to prevent clipping. To enable the limiter, rotate either Adjust
knob to the right until the LCD screen displays
On . To disable the limiter, rotate either knob
to the left until Off is displayed. The default is Off .