ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 98)

ZyWALL 10~100 Series Internet Security Gateway
8-2 WAN Screens
Figure 8-1 WAN Setup: Route
The following table describes the fields in this screen.
Table 8-1 WAN Setup: Route
LABEL DESCRIPTION
WAN
Traffic
Redirect
Dial Backup
The default WAN connection is "1' as your broadband connection via the WAN port
should always be your preferred method of accessing the WAN. The default priority of
the routes is WAN, Traffic Redirect and then Dial Backup (dial backup does not apply
to all ZyWALL models):
You have two choices for an auxiliary connection in the event that your regular WAN
connection goes down. If Dial Backup is preferred to Traffic Redirect, then type "14" in
the Dial Backup Priority (metric) field (and leave the Traffic Redirect Priority (metric)
at the default of "15").
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
8.4 Configuring WAN ISP
To change your ZyWALL’s WAN ISP settings, click WAN, then the WAN ISP tab. The screen differs by the
encapsulation.
8.4.1 Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.