ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 146)

ZyWALL 10~100 Series Internet Security Gateway
11-2 Firewalls
i. Information hiding prevents the names of internal systems from being made known via DNS to
outside systems, since the application gateway is the only host whose name must be made known to
outside systems.
ii. Robust authentication and logging pre-authenticates application traffic before it reaches internal
hosts and causes it to be logged more effectively than if it were logged with standard host logging.
Filtering rules at the packet filtering router can be less complex than they would be if the router needed
to filter application traffic and direct it to a number of specific systems. The router need only allow
application traffic destined for the application gateway and reject the rest.
11.2.3 Stateful Inspection Firewalls
Stateful inspection firewalls restrict access by screening data packets against defined access rules. They make
access control decisions based on IP address and protocol. They also "inspect" the session data to assure the
integrity of the connection and to adapt to dynamic protocols. These firewalls generally provide the best
speed and transparency; however, they may lack the granular application level access control or caching that
some proxies support. See section 11.5 for more information on Stateful Inspection.
Firewalls, of one type or another, have become an integral part of standard security solutions for enterprises.
11.3 Introduction to ZyXEL’s Firewall
The ZyWALL firewall is a stateful inspection firewall and is designed to protect against Denial of Service
attacks when activated (in SMT menu 21.2 or in the web configurator). The ZyWALL’s purpose is to allow a
private Local Area Network (LAN) to be securely connected to the Internet. The ZyWALL can be used to
prevent theft, destruction and modification of data, as well as log events, which may be important to the
security of your network. The ZyWALL also has packet-filtering capabilities.
The ZyWALL is installed between the LAN and a broadband modem connecting to the Internet. This allows
it to act as a secure gateway for all data passing between the Internet and the LAN.
The ZyWALL has one Ethernet WAN port and one Ethernet LAN port, which are used to physically separate
the network into two areas.
The WAN (Wide Area Network) port attaches to the broadband modem (cable or ADSL) connecting to
the Internet.
The LAN (Local Area Network) port attaches to a network of computers, which needs security from the
outside world. These computers will have access to Internet services such as e-mail, FTP, and the World
Wide Web. However, “inbound access” will not be allowed unless the remote host is authorized to use a
specific service.