ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 375)

ZyWALL 10~100 Series Internet Security Gateway
Remote Node Setup 27-13
Figure 27-9 Menu 11.6: Traffic Redirect Setup
The following table describes the fields in this screen.
Table 27-6 Menu 11.6: Traffic Redirect Setup
FIELD DESCRIPTION EXAMPLE
Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic
redirect setup. The default is No.
When the Active field is Yes, you must configure every field in this screen
unless you are using PPPoE or PPTP encapsulation (except Check WAN
IP Address and Timeout).
If you don’t configure these fields and are using PPTP or PPPoE
encapsulation, then the ZyWALL checks the PPPoE channel or PPTP
tunnel to determine if the WAN connection is down.
Yes
Configuration:
Backup
Gateway IP
Address Enter the IP address of your backup gateway in dotted decimal notation.
The ZyWALL automatically forwards traffic to this IP address if the
ZyWALL’s Internet connection terminates.
0.0.0.0
Metric Enter a number from 1 to 15 to set this route’s priority among the
ZyWALL’s routes (see the Metric section in the WAN and Dial Backup
Setup chapter) The smaller the number, the higher priority the route has. 15
(default)
Menu 11.6 - Traffic Redirect Setup
Active= Yes
Configuration:
Backup Gateway IP Address= 0.0.0.0
Metric= 15
Check WAN IP Address= 0.0.0.0
Fail Tolerance= 2
Period (sec)= 5
Timeout (sec)= 3
Press ENTER to Confirm or ESC to Cancel: