ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 496)

ZyWALL 10~100 Series Internet Security Gateway
39-6 VPN/IPSec Setup
39.3 IPSec Setup
Select Edit in the Select Command field; type the index number of a rule in the Select Rule field and press
[ENTER] to edit the VPN using the menu shown next.
Figure 39-4 Menu 27.1.1: IPSec Setup
You must also configure menu 27.1.1.1 or menu 27.1.1.2 to fully configure and use
a VPN.
Table 39-2 Menu 27.1.1: IPSec Setup
FIELD DESCRIPTION EXAMPLE
Index This is the VPN rule index number you selected in the previous menu. 1
Name Enter a unique identification name for this VPN rule. The name may be up
to 32 characters long but only 10 characters will be displayed in Menu
27.1 - IPSec Summary. Taiwan
Active Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to activate the VPN tunnel. This field determines whether a VPN
rule is applied before a packet leaves the firewall. Yes
Menu 27.1.1 – IPSec Setup
Index= 1 Name= Taiwan
Active= Yes Keep Alive= No NAT Traversal= No
Local ID type Content:
My IP Addr= 0.0.0.0
Peer ID type Content:
Secure Gateway Address= zw50test.zyxel.com.tw
Protocol= 0
Local: Addr Type= SINGLE
IP Addr Start= 1.1.1.1 End= N/A
Port Start= 0 End= N/A
Remote: Addr Type= SUBNET
IP Addr Start= 4.4.4.4 End= 255.255.0.0
Port Start= 0 End= N/A
Enable Replay Detection = No
Key Management= IKE
Edit Key Management Setup= No
Press ENTER to Confirm or ESC to Cancel: