ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 363)

ZyWALL 10~100 Series Internet Security Gateway
Remote Node Setup 27-1
Chapter 27
Remote Node Setup
This chapter shows you how to configure a remote node. SMT menus 11 and 11.2 and
traffic redirect do not apply to the ZyWALL 10. SMT menu 11.1 opens directly in the
ZyWALL 10.
27.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring a remote node. The following describes how to configure
Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options and Menu 11.5 -
Remote Node Filter.
27.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 Remote Node Setup (shown below).
Then enter 1 to open Menu 11.1 Remote Node Profile and configure the setup for your regular ISP. Enter
2 to open Menu 11.1 Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup
port connection (see the WAN and Dial Backup Setup chapter).