ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 334)

ZyWALL 10~100 Series Internet Security Gateway
23-6 WAN and Dial Backup Setup
Table 23-4 Advanced WAN Port Setup: Call Control Parameters
FIELD DESCRIPTION DEFAULT
Drop Timeout
(sec)
Enter a number of seconds for the ZyWALL to wait before dropping
the DTR signal if it does not receive a positive disconnect
confirmation. 20 seconds
Call Back Delay
(sec)
Enter a number of seconds for the ZyWALL to wait between
dropping a callback request call and dialing the co-responding
callback call. 15 seconds
23.6 Remote Node Profile (Backup ISP)
Enter 2 in Menu 11 Remote Node Setup to open Menu 11.1 Remote Node Profile (Backup ISP) (shown
below) and configure the setup for your Dial Backup port connection. This feature is not available on all
models.
Figure 23-4 Menu 11.1 Remote Node Profile (Backup ISP)
The following table describes the fields in this screen.
Table 23-5 Fields in Menu 11.1 Remote Node Profile (Backup ISP)
FIELD DESCRIPTION EXAMPLE
Rem Node
Name Enter a descriptive name for the remote node. This field can be up to
eight characters. LAoffice
Menu 11.1 - Remote Node Profile (Backup ISP)
Rem Node Name= ? Edit PPP Options= No
Active= Yes Rem IP Addr= 0.0.0.0
Edit IP= No
Outgoing: Edit Script Options= No
My Login=
My Password= ******** Telco Option:
Authen= CHAP/PAP Allocated Budget(min)= 0
Pri Phone #= ? Period(hr)= 0
Sec Phone #= Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel: